Adjusting The Volume; Reset Function - INTEZZE HUB Bedienungsanleitung

Adjusting the volume

The Intezze HUB is only a passive receiver/transmitter and therefore cannot
adjust the volume. This must be adjusted directly on the signal source (TV) or on
the headphones or speakers.

RESET function

1) Connect the HUB to the power supply using a micro-USB cable and turn it
on with the switch on the back (RX or TX mode).
2) Hold the slide switch on the front panel to the far right until the red-blue
flashing of the LED indicator light stops for a moment and resumes (hold
for up to 13 seconds). You can then release the switch.
3) The device is now in pairing mode again, and all previously paired devices
have been cleared from the memory.
LED indicator lights
STATUS
Off
On – optics
On – AUX
Pairing
Paired – optics
Paired – AUX
EN
LED indicator lights
LED light off
blue light flashing twice in quick succession
green light flashing in quick succession
blue and red light flashing
blue light on
green light on