INTEZZE HUB Bedienungsanleitung Seite 5

Connection in TX – Transmitter Mode
Connection to TV/computer
In transmitter mode, it is necessary to connect the HUB to an audio signal source
(computer, TV, MP3 player, etc.). Use one of the available options:
a) Using the optical cable. Digital optical output is available on newer TVs.
Connect it to the Digital Optical Audio IN on the HUB.
Alternatively, you may need to select digital PCM output in the TV settings.
Using the RCA cable. Analogue connection is available on most TVs. Use
b)
the supplied AUX jack cable together with the RCA adapter and connect the
RCA audio output of the TV to the 3.5 mm AUX Audio IN on the HUB.
c) Using the AUX 3.5 mm jack cable. Use this cable to connect the HUB to the
headphone output of the TV. Use the 3.5 mm AUX Audio IN again on the
HUB.
Pairing in TX – Transmitter Mode
Pairing with BT headphones/BT speakers
1) Connect the product to the TV or other signal source by following the
instructions in the previous chapter.
2) Slide the switch on the back to the TX position.
3) On the front panel, hold the slide switch to the far right (BT) until the LED
indicator light alternately flashes red and blue. Pairing mode is now active.
EN