INTEZZE HUB Bedienungsanleitung Seite 7

Connection in RX – Receiver Mode
Connection to the audio system/active speakers
In Bluetooth receiver mode, only output that can transmit a signal to the
connected device is used on the back of the HUB. There are 3 options to connect
the device:
a) Using the optical cable. Some audio systems/active speakers are equipped
with a digital optical input. Connect it to the Digital Optical Audio OUT on
the HUB.
Using the RCA cable. Analogue connection is available on most audio
b)
devices. Use the supplied AUX jack cable together with the RCA adapter
and connect the RCA audio input on the home system to the 3.5 mm AUX
Audio OUT output on the HUB.
c) Using the AUX 3.5 mm jack cable. If your home appliance is equipped with
a 3.5 mm jack audio input (headphone output cannot be used), use the
AUX jack connecting audio cable - 3.5 mm jack included in the package.
Pairing in RX – Receiver Mode
Pairing with a phone/tablet
1) First, complete the connection to the home audio device by following the
instructions in the previous chapter.
2) Slide the switch on the back to the RX position.
EN