INTEZZE HUB Bedienungsanleitung Seite 6

4) Switch the headphones to pairing mode as well so that they can be paired
with the HUB. When pairing is complete, the LED indicator light stops
flashing and turns blue (OPT)/green (AUX). Pairing mode automatically
turns off after 30 seconds.
5) Make sure that the input used on the back of the HUB corresponds to the
selected option on the front (analogue AUX or digital OPT).
Multi-point pairing with two devices simultaneously
The product can stream audio to two devices simultaneously. Once one device is
connected, it is possible to pair the other device with the HUB.
1) Pair and connect the first pair of headphones first by following the
instructions in the previous chapter.
2) Hold the switch on the front to the far right to activate pairing mode on the
HUB (the LED indicator light flashes red and blue again).
3) Switch the other pair of headphones to pairing mode so that they can be
connected to the HUB. The sound will then be transmitted to both
headphones simultaneously.
Intezze HUB always selects the best available codec supported by the
headphones (ideally aptX Low Latency). If at least one pair of headphones
supports this codec, it will be used automatically for both currently connected
devices.
EN