INTEZZE HUB Bedienungsanleitung Seite 4

Modes
TX Mode – Bluetooth transmitter
Connect the Intezze HUB to a device that is not equipped with a Bluetooth
interface (TV, PC). The HUB then allows you to send the audio signal from these
devices wirelessly to BT headphones/BT speakers and other devices.
RX Mode – Bluetooth receiver
Connect the Intezze HUB to a device that is not able to receive a Bluetooth signal
wirelessly. You can then send music from your phone/tablet to the Intezze HUB,
which transmits it via a cable (analogue/digital) to your home audio system or
speakers.
Switching On and Mode Selection
Using the adhesive gel strip, you can attach the Intezze HUB to a
table/monitor/TV as required.
1) Use the provided micro-USB cable to connect the HUB to a powered USB
connector (on a TV, make sure the USB output is powered) or preferably to
a charger.
2) Use the switch on the back to select the desired TX/RX mode. The LED
indicator light on the top will start flashing twice in quick succession.
3) To switch off the device, move the same switch to the central OFF position.
EN