PeakTech 3433 Bedienungsanleitung Seite 28

4.5. Detecting wooden objects
1. When looking for wooden objects, position the measuring
device on the desired surface. By pressing the wood mode
button "4", the LED display lights up green until the measuring
device has completed the calibration. The display symbol "h" of
the wood detection now appears in the display. Now position
the measuring device on the desired surface and move it
around. When the measuring device approaches a wooden
object, the display of the measuring indicator "j" increases and
a signal tone sounds with a rapid sequence of tones. Move the
measuring device over the surface repeatedly to find the center
of the scanned object. At the position of maximum display, the
wooden object is below the center of the sensor. At this point
the "i" indicator is shown on the display, a continuous tone
sounds and the LED indicator "1" lights up red. As the meter
moves away from the object, the display will decrease. If the
wooden object is too deep or too small, the LED of the detector
"1" lights up yellow.
Attention! When wooden objects are detected, the measuring
display increases and the signal tone sounds with a rapid
sequence of tones; the display also flashes red or yellow when
the measuring device is positioned on the base material to be
detected. If the above conditions have occurred, the process
must be repeated. The wood mode button "4" must be pressed
based on the detected material. The LED display 1 lights up
green and shows the calibration. If the detector searches for
wood objects again or on another wall or surface, the wood
mode button "4" must be pressed repeatedly. After a short self-
test, the LED display "1" lights up green and shows the
calibration. Only then should you start measuring.
28