PeakTech 3433 Bedienungsanleitung Seite 27

Note: Wires that are live can be identified more easily. For
example, lamps are connected to a line that is currently being
searched for. Lines with 110V, 220V and 380V (three-phase
current) are detected with approximately the same scanning
capacity.
Attention! Under certain conditions, for example metal surfaces
or under surfaces with a high water content, live wires cannot
always be reliably detected. The signal strength of live wires
depends on the position of the cable. You should therefore apply
further measurements in the immediate vicinity or use other
sources of information to check whether a live line is present. If
you move the measuring tool repeatedly over the area, you will
localize the live wire more precisely.
Static electricity can cause the electrical wiring to be inaccurate,
for example over a large area. To improve the reading, place
your free hand flat against the wall next to Measuring device to
remove the static electricity. Moving the detector quickly creates
the static electricity. Please move slowly if you want to find live
wires.
27