PeakTech 3433 Bedienungsanleitung Seite 19

1. Introduction
Intended use 1.1.
This practical wall scanning device is used in preparation of drilling,
slitting or chiseling work and was developed to find metal, wood and
live conductors in walls, floors or ceilings. The inverted and easy-to-
read LCD display visually shows the distance to the material found
and helps the user to evaluate the internal condition of the wall before
e.g. pipes are damaged or short-circuits in power lines occur. The
scanning depth of the sensor lies between 20mm (wood) and 120mm
(ferrous metal) depending on the material sought. In addition, an LED
(green, yellow, red) indicates whether a material has been found or if
there is a danger of electrical shock at the current test location. The
PeakTech 3433 is protected against the ingress of dust and jet water
in protection class IP54 for a safe daily use. The simple operation,
safe application and high-quality workmanship make this model an
indispensable companion for every craftsman, do-it-yourselfer or
installer for maintenance and all work in the building sector.
1.2. Features
- LED light (green, yellow, red) with acoustic signal
- Measuring depth up to 120mm, depending on the material
- Distance display to measuring material
- Inverted LCD display 6cm with lighting
- IP 54 water and dust protected
- Metal / Electricity mode to find metal or electricity
- Wood mode button for finding wood
- Hand strap for optimal transport of the device
- Automatic switch-off after 5 min.
- Self-calibration when switching on
- Detection of ferrous and other metals
19