Installation Notes - Klarstein MR. BARBOT Bedienungsanleitung

EN
14

INSTALLATION NOTES

It is important that upon receipt you stand your appliance upright for at least 4 hours
before switching on to allow the system to settle.
• The appliance should not be tilted more than 45 degrees when you move it. Do not
use force on any part such as the condenser, the door or handle. They could distort
and affect the operation of the cooler. Ensure ALL packaging is removed before
installation.
• Make sure there is enough ventilation space around product.
• The appliance should not be installed near external heat sources e.g. direct sun
shine or external moisture sources.
• Ensure the supply voltage of socket is same as rating label.
• The plug must be properly inserted to the wall socket.
• The mains supply socket must be earthed - preferably with a switch. If it is not
earthed, do NOT install this appliance there. Do not use an extension cord.
• The product is equipped with adjustable feet. Once the product is in place, adjust
these to ensure the fridge is level and doesn't rock.
Note: Leave at least 15 cm of space around the unit to ensure good cooling
performance.