Electrolux EK274BNLWE Benutzerinformation Seite 20

20 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
DEMO appears on the dis‐
play.
Possible cause
Stored food was not wrap‐
ped.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The "Frostmatic function"
or "Coolmatic function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The Frostmatic function is
switched on.
The Coolmatic function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in demon‐
stration mode.
Solution
Wrap food in suitable
packaging before storing it
in the appliance.
Attach the melting water
outlet to the evaporative
tray.
Switch off "Frostmatic
function" or "Coolmatic
function" manually, or wait
until the function deacti‐
vates automatically to set
the temperature. Refer to
"Frostmatic function" or
"Coolmatic function" sec‐
tion.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "Frostmatic func‐
tion" section.
Refer to "Coolmatic func‐
tion" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and Tips" chapter.
Keep the OK key pressed
for approximately 10 sec‐
onds until a long sound is
heard and the display turns
off for a short time.