Bosch KI25R-Serie Gebrauchsanleitung Seite 27

Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out mains plug or switch off fuse.
3. Take out the food and store in a cool
location. Place ice pack (if available)
on the food.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light or through
the drainage hole into the evaporation
pan.
6. Wipe the door seal with clear water
only and then wipe dry thoroughly.
7. After cleaning reconnect and switch
the appliance back on.
8. Put the food back into the appliance.
Notes
Regularly clean the condensation
■
channel and drainage hole, Fig. )/B,
with a cotton bud to ensure that
the condensation can drain.
The water conduction channel,
Fig. )/A, can be taken out for
cleaning.
After cleaning, the stopper must be
■
re-inserted into the drainage hole
of the refrigerator compartment for
functional reasons.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Taking out the glass shelf "EasyLift"
Fig. %
Move glass shelf all the way upwards
and take out.
Taking out the door shelf "EasyLift"
Fig. &
Move door shelf all the way upwards and
take out.
Taking out the fixed glass shelf
Fig. '
Press buttons on the underside and
detach from the fixing.
Removing the container
Fig. *
Tilt container forwards and take out.
To insert the container, place the front
of the container on the telescopic rails
and push into the appliance.
The container is engaged by pushing
it into the appliance.
Remove telescopic rails
Fig. ,
1. Pull out the telescopic rail.
2. Push lock in the direction of the arrow.
3. Detach telescopic rail from the rear
pin.
4. Push telescopic rail together, push
backwards above the rear pin
and disengage.
Installing telescopic rails
1. Place the extended telescopic
rail on the front pin.
2. Pull the telescopic rail forwards
slightly until it engages.
3. Place telescopic rail on the rear pin.
4. Push lock backwards.
en
27