Optional Accessories; Replacing Carbon Brushes - Makita HS6100 Bedienungsanleitung

Rip fence (Guide rule)
► Fig.22: 1. Clamp lever 2. Rip fence (Guide rule)
The handy rip fence allows you to do extra-accurate
straight cuts. Simply slide the rip fence up snugly
against the side of the workpiece and secure it in posi-
tion with the clamp lever on the front of the base. It also
makes repeated cuts of uniform width possible.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Adjusting for accuracy of 0° and 45°
cut (vertical and 45° cut)
► Fig.23: 1. Adjusting screw for 0° 2. Adjusting screw
for 45°
► Fig.24: 1. Triangular rule
This adjustment has been made at the factory. But if it is
off, adjust the adjusting screws with a hex wrench while
inspecting 0° or 45° the blade with the base using a
triangular rule or square rule, etc.
Adjusting for parallelism
► Fig.25: 1. Base 2. Screw 3. Saw blade
The parallelism between the blade and the base has
been factory adjusted. But if it is off, you can adjust it as
the following procedure.
Make sure all levers and screws are tightened. Slightly
loosen the screw as illustrated. While opening the lower
guard, move the rear of base so that the distance A and
B are equal. After adjusting, tighten the screw. Make a
test cut to get a correct parallelism.

Replacing carbon brushes

► Fig.26: 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
► Fig.27: 1. Screwdriver 2. Brush holder cap
After replacing brushes, plug in the tool and break in brushes
by running tool with no load for about 10 minutes. Then check
the tool while running and electric brake operation when
releasing the switch trigger. If the electric brake is not working
correctly, have the tool repaired by a Makita service center.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
All manuals and user guides at all-guides.com
OPTIONAL
ACCESSORIES
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
•
•
•
•
•
10 ENGLISH
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
Saw blades
Rip fence (Guide rule)
Guide rail
Guide rail adaptor
Hex wrench
Joint
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.