Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Cleaning
Clean out sawdust and chips from time to time. Carefully
clean the blade guard and moving parts inside the table saw.
When removing the sawdust accumulated under the saw
blade, remove the table insert and use an air duster to blow
out the sawdust from the connector for a vacuum cleaner.
Lubrication
To keep the table saw in tip-top running condition, and
to assure maximum service life, oil or grease the mov-
ing parts and rotating parts from time to time.
Lubrication places:
•
Threaded shaft to elevate the saw blade
•
Hinge to rotate the frame
•
Elevation guide shafts on motor
•
Gear to elevate the saw blade
•
Guide rails for the rip fence
•
Shaft of the sub table (R) locking levers
•
Sliding part of the sub table (R)
Replacing carbon brushes
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
► Fig.47: 1. Limit mark
1.
Store the sub table (R). Remove the rip fence if it is stored.
2.
Loosen the lock lever and turn the handwheel
until the saw head is tilted to 45° bevel angle. After that,
tighten the lock lever.
► Fig.48: 1. Rip fence 2. Lock lever 3. Handwheel
3.
Stand the tool on its right side.
► Fig.49
4.
Loosen the screws on the bottom plate and remove it.
5.
Loosen the brush holder caps using a screwdriver
and remove the worn carbon brushes.
► Fig.50: 1. Bottom plate 2. Brush holder cap
3. Screwdriver
6.
Insert the new carbon brushes and secure the
brush holder caps.
7.
Attach the bottom plate with screws and carefully
lay the tool on its bottom. Store the rip fence if removed.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
Steel & Carbide-tipped saw blades
•
Sub table (L)
•
Sub table (back)
•
Rip fence
•
Miter gauge
•
Offset wrench 13-22
•
Wrench 19
•
Hex wrench 5
•
Joint (for connecting to dust collector)
•
Table stand set
Refer to the instruction manual for table saw stand
that is provided with the table saw stand as an optional
accessory.
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
17 ENGLISH
Werbung
Inhaltsverzeichnis
