Home Connect - Bosch KAD-Serie Montage- Und Gebrauchsanleitung

en
2. Activate by pressing the setting button + (function is
framed).
Switching off the [eco]
1. Keep pressing the "options" button, until the [eco]
function is marked with an arrow.
2. Deactivate by pressing the setting button - (function
is no longer framed).
[vacation]
If leaving the appliance for a long period of time, you
can switch the appliance over to the energy-saving
vacation mode. The refrigerator compartment
temperature is automatically switched to +14 °C.
m
Caution
Do not store any food in the refrigerator compartment
during this time!
Switching on the [vacation]
1. Keep pressing the "options" button, until
the [vacation] function is marked with an arrow.
2. Activate by pressing the setting button + (function is
framed).
Switching off the [vacation]
1. Keep pressing the "options" button, until
the [vacation] function is marked with an arrow.
2. Deactivate by pressing the setting button - (function
is no longer framed).
[clock]
The time is indicated on the time display panel. You
can set the time with the [clock] function.
Setting the time
1. Keep pressing the "options" button, until the [clock]
function is marked with an arrow.
2. Activate by pressing the setting button + (function is
framed).
3. Press the setting buttons +/- to set the required time.
4. Save the set time with the "options" button.
Note
If the [timer] function is switched on, the time is not
displayed.
[IWD off]
You can use this function to switch off the ice and water
dispenser.
m
Caution
Before switching off the ice maker, it is most
■
important that you switch the water supply
to the appliance off for a few hours.
Empty and clean ice cube container. Re-attach
■
the ice cube container. Ensure that the ice cube
container engages with the support.
Switching on [IWD off]
1. Keep pressing the "options" button, until
the [IWD off] function is marked with an arrow.
42
2. Activate by pressing the setting button + (function is
framed).
Switching off [IWD off]
1. Keep pressing the "options" button, until
the [IWD off] function is marked with an arrow.
2. Deactivate by pressing the setting button - (function
is no longer framed).
[filter change]
After 6 months you are prompted via the [filter change]
display message to replace the filter cartridge.
Activating new filter cartridge
When the filter cartridge has been replaced,
the [filter change] function must be re-activated.
1. Change filter cartridge (see chapter "Water filter").
2. Keep pressing the "options" button, until the [filter
change] function is marked with an arrow.
3. Activate by pressing the setting buttons +/-. [filter
change] display goes out.

Home Connect

This appliance is Wi-Fi-capable and can be remotely
controlled using a mobile device.
Note
Wi-Fi is a registered trade mark of the Wi-Fi Alliance.
If the appliance is not connected to the home network,
the appliance functions like a refrigerator without a
network connection, and can still be manually operated
via the controls.
In order to use the Home Connect functions, connect
the appliance to a Home Connect Wi-Fi dongle.
If a Home Connect Wi-Fi dongle is not supplied with
your appliance, you can order this from Customer
Service.
Note
The connection and disconnection of the appliance
plug may be more difficult to perform than expected.
Attach the Wi-Fi dongle at a height of one metre.
Notes
Please observe the safety information in these
■
operating instructions and ensure that this is still
adhered to, even if you operate the appliance via the
Home Connect app and are not at home when doing
so. See the 'Safety and warning information' section.
You must also follow the instructions in the Home
Connect app.
Operation on the appliance always has priority.
■
During this time, it is not possible to operate the
appliance using the Home Connect app.