Installation - Hauck Roll-A-Round III Gebrauchsanweisung

INStALLAtIoN

GB
Setting it up (fig. 1)
Set the baby-walker up by grasping the upper part of the table and pulling it up to the
highest position. the height is adjustable into  positions.
Wheels (fig. )
Place the baby-walker upside down on a flat floor. Press the wheels with the plastic
pins into the mounts until they click in. Make sure they are firmly in place.
Seat attachment
to fasten the seat attachment, press the plastic pins into the corresponding seat unit
holes and lock into place by pressing the pins downwards. Do check that it is firmly in
place before you put your child into the baby-walker.
Height adjustment (fig. a,b)
the height is adjustable into  positions. Detach the safety bolt, then press the
adjustment button on the underside and put the baby-walker in the position required.
Next fasten the baby-walker with the safety bolt you previously detached.
Play part (fig. 4)
Insert the electronic play part into the corresponding mount. the battery compartment
is on the underside of the play board. Use only  x 1.5 V R6 batteries. Check polarity
when inserting the batteries.
Stopper (fig. 5)
the baby-walker can be fixed to the floor using a stopper. to do this, turn the stopper
to the right to fix in position and to the left to unlock.