Connecting The Machine To The Mains; Switching On For The First Time: Installing The Software; Switch On The Monitor And The Machine - Fujitsu SIEMENS AMILO S Serie Erstinbetriebnahme

Getting started

Connecting the machine to the mains

Mains adapter,
1
► Connect the mains cable to the machine (1).
► Plug the mains plug into a three-pin socket (2).
Switching on for the first time: installing the software
Installing, Software, Installing,
If the device is integrated into a network, the user and server details as well as the
network protocol are required during the software installation.
When you switch on the device for the first time, the supplied software is installed and configured.
Plan a reasonable amount of time for this, as this process must not be interrupted.
Once the installation has been started the device must not be switched
off, unless the installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.

Switch on the monitor and the machine

► Switch on the monitor (see operating instructions for the monitor).
14 - English
2
10600985317, edition 1