Chicago Pneumatic CP7600xC Serie Bedienungsanleitung Seite 5

Single torque selector
Adjust the torque setting by means of the adjustment key. The
torque is increased when screwing the screw counter clockwise.
After adjustment, check the tightening torque given to the joint in
question.
A
If shut-off is carried out at high speed of revolution, causing a
high torque scatter, it is recommended to reduce the air pres-
sure.
4-position selector
In order to set Torque 1, turn the rotary switch to the ref. mark on
the housing. Set the adjustment screw 1. See mark on the switch
how to increase/decrease the torque. To set Torque 2, turn the
rotary switch to the Ref. 2 mark on the housing. Set the adjustment
screw 2.
EN
+Nm -Nm
CCW CW
+ Nm Nm
CCW CW
Remember your torque settings by placing your own markings on
the four areas on the housing.
Operating instructions
Tightening torque selection
Push the black button. Turn the rotary switch to desired position.
Push the rotary switch back in.
Part no 8940164682
Issue no 1
Series no 1
Date 2010-01
Page 5