Assembling The Appliance; Dry Vacuuming - Hoover Jet & Wash SX 6254 Bedienungsanleitung

heat or chemical substances, nor that it is pulled
across sharp edges or surfaces.
• Avoid using extension cables in wet rooms.
• Never repair damage to the appliance, to the
accessories or to the cable (special cable required);
have repairs done only by an authorised Hoover
Service Engineer, because modifications to the
appliance can pose a risk to your health. Ensure that
only original spare parts and accessories are used.
• Do not expose the appliance to the elements,
humidity or heating sources.
• Never aim the cleaning jet at people or animals, at
electrical sockets or electrical appliances.
• After wet vacuuming, empty the collecting bin
immediately.
• Chemicals such as the cleaning fluid concentrates
should not be handled by children.
• The functionality and complete effectiveness of the
appliance can only be warranted if you use original
Hoover cleaning fluids.
• Persons with sensitive skins should avoid direct
contact with the cleaning fluid.
• If cleaning fluid comes into contact with mucous
membranes (eyes, mouth, etc.), immediately flush
with water.
We care about the environment
We care about the environment
Do not simply throw out packing materials and old
appliances!
Packing materials:
Take the packing carton to paper recycling collection
points.
Take the polyethylene (PE) plastic bag to collection
points to be reused.
What to do with the appliance after the end
of its useful life:
Dispose of the appliance according to local regulations
and pull out and cut off the mains cable beforehand.
Assembly
Undo the snap-on fasteners and lift the motor
A
block.
B Place footring with the 4 holes to match with the
holes on the underside of tank and fix it by
plugging in the fixing elements.
Push the castor wheels and the pegs into the
footring until they snap into place.
G To connect the suction hose
Push the suction hose connection piece into the
tank suction connection and turn to the right as
far as it will go. To remove the suction hose turn
the connection piece to the left and pull out.

Dry vacuuming

After wet vacuuming, the appliance must be
absolutely dry; dry off the flexible hose or tubes
if necessary beforehand.
Never dry vacuum without filters or
with damaged filters.
Remove the cleaning fluid tank.
H
Assemble the foam rubber filter, tissue filter and
C
clamping ring and fasten them with the turning
clips.
Press the Paper Filter Bag on the suction
D
connection firmly and lay it against the wall of the
collecting bin.
Clip the hose for the cleaning fluid to the
E
underside of the motor block.
F Place the motor block on top and secure it by
means of snap-on fasteners.
Connecting the flexible hose. Remove the hose by
G
turning the hose connecting piece and
withdrawing the hose.
Assemble the accessories you require.
Connect the mains cable.
Turn the appliance on with the On/Off switch.
L
The pump switch (7) must not light up.
Suction control (11, figure N) allows you to vary
the suction power.
– Sliding air trap closed = full suction power
– Sliding air trap open = reduced suction power
7