Product Description; Commissioning; Operation; Switching The Convector On/Off - Bosch Heat Convector 4000 Bedienungsanleitung

2.5

Product description

The Heat Convector 4000 is a wall mounted or floor standing
electric plate space heating convector ( Fig. 1, page 211).
Legend for figure 1, page 211:
[1] Convector
[2] Display
[3] On/Off switch
3

Commissioning

If the appliance is installed or set up in or was previously stored
in a much colder environment, it must be allowed to adjust to
the room temperature.
▶ Wait half an hour before switching on the appliance.
When the appliance is heating for the first time, it may emit a
slightly unpleasant odour (for 2 hours at the most) which is
caused by the product residues drying out.
4

Operation

▶ Observe safety instructions ( Chapter 1.2, page 56).
4.1

Switching the convector on/off

The convector is switched on and off at the ON/OFF switch
( Fig. 1, [3], page 211).
To switch on the convector:
▶ Set the switch to I.
To switch off the convector:
▶ Set the switch to 0.
Only switch off the convector via the ON/OFF switch if you will
not be needing it for a while, e.g. at the end of the heating
period.
Heat Convector 4000 – 6720883017 (2020/11)
4.2

Operation of the control unit

The control elements of the control unit are shown in Chapter
4.5, page 60.
The control unit has no date memory. The date and time will be
lost if the convector is disconnected from the mains power
supply for longer than 5 seconds (by pulling out the plug). The
heating programs are retained.

4.2.1 Switching on the control unit

On/Off key
Press the key ( Fig. 2, [7], page 211) to switch the control
unit on and off with the display.
To switch the control unit on:
▶ Press button.
To switch the control unit off:
▶ Press the key for longer than 5 seconds.
When the control unit is switched on, the last operation mode
used appears in the display with the current settings.
When the display is switched on for the first time, the heating
mode operation mode is set. The default setting for the
temperature in the heating mode operation mode is 19 °C.
If the display is no longer touched, it goes dark after 5 minutes.
4.3

Parameter settings and settings

4.3.1 Calling up the Parameter settings menu

The appliance settings can be made in the Parameter settings
menu.
To call up the Parameter settings menu:
▶ Press the key repeatedly until the indicator light above
the pictogram lights up.
no flashes.
▶ Press the or key until go appears.
▶ Press the key to confirm go.
The Parameter settings menu appears on the display.
Commissioning
59