Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
4.3.2 Calling up the Settings menus
The following settings menus can be called up:
•
Day of the week and time (d/HH/MM)
•
Day program (P6)
•
Week program (7d)
•
Window open function (][)
To call up the Settings menu:
▶ Call up the Parameter settings menu.
▶ Press the
key repeatedly until the indicator light of the
required menu lights up.
4.3.3 Exiting the Parameter settings menu
To exit the Parameter settings menu:
▶ Press the
key repeatedly until the indicator light above
the pictogram
lights up.
no flashes.
▶ Press the
key to confirm no.
The appliance is in the heating mode operating mode.
4.5
Operating modes and displays on the control unit
Position
Operation
mode
1
Heating
mode
2
ECO
3
PROG
4
TIMER
Table 54 Operating modes at the control unit (
60
Description
Setting the temperature for the heating mode operating
mode.
Energy saving operating mode. The temperature
default setting is 3 °C below the temperature of the
heating mode operating mode.
Changeover automatically between the heating mode
operating mode and ECO operating mode.
Timer for the time program for switching the appliance
on/off.
Fig. 2, page 211)
The control unit exits the menu automatically if there has been
no activity for 60 seconds in one of the settings menus. The
appliance then reverts to the heating mode operating mode.
4.4
Setting the day and time
The day of the week and time must be set before the day
program and week program can be set.
To set the day of the week and the time:
▶ Call up the Parameter settings menu
( Chapter 4.3.1, page 59).
The Day of the week and time menu appears on the display.
d/1 flashes on the display and the day of the week can be
Heat Convector 4000 – 6720883017 (2020/11)
Chapter 4.5.2, page 61
Chapter 4.5.3, page 61
Chapter 4.5.4, page 62
Chapter 4.5.5, page 63
Chapter 4.5.6, page 63
Chapter 4.5.7, page 64
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
