Operation; Electromagnetic Fields - NARDA ADFA Handhabung

2.5

Operation

Electrical voltages are present inside the unit.
 Do not bring the ADFA into contact with live parts.
 Do not open the ADFA. Opening the ADFA invalidates any warranty
claim.
 Only use accessories intended for the ADFA.
Operation of a damaged ADFA or accessories may result in significant
measurement errors and consequential damages.
 Check the ADFA and accessories regularly for damage. Cracks or
fractures in the housing indicate possible interior damage and, thus,
possible incorrect measurement results.
 In the event of damage or suspected malfunction, take the ADFA out of
operation and contact your responsible sales partner. Addresses can be
found on the Internet under http://www.narda-sts.com.
2.6

Electromagnetic fields

Strong electromagnetic fields
Very strong electromagnetic fields are generated in the vicinity of
certain radiation sources, which can lead to injuries or death in the
case of endangered persons.
 Observe safety barriers and markings.
 People with active implants in particular must avoid dangerous areas.
Extreme field strengths can damage the sensor.
 If necessary, immediately remove the device from the environment of the
field source.
Unsuitable frequency range
By selecting an unsuitable frequency range, dangerous fields can be
overlooked. Staying within such fields may cause injury or death to
persons at risk.
 Select the largest selectable or appropriate frequency range.
 Only approach unknown field sources with careful observation of the
current measured and displayed value.
 In case of doubt, also use a wideband-measurement warning device
such as RadMan or Nardalert from Narda Safety Test Solutions.
36 Automatic DF Antenna Narda