Instruction For The User; Lighting The Burners - Zanussi zgg 643 Bedienungsanleitung

Instruction for the User

Hob burners control knobs
The hob burners control knobs are situated on the hob
right hand side. The symbols on the knobs mean that :
there is no gas supply
"
there is maximum gas supply
there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a
pan on the pan support.
!
To light a burner, turn the relevant knob anticlockwise
to maximum position and push down the knob to
ignite.
After lighting the flame, keep the knob pushed
down for about 5 seconds. This will allow the
"thermocouple" (Fig. 1 lett. B) to be heated and the
safety device to be switched off, otherwise the gas
supply would be interrupted. Then, check the flame
is regular and adjust it as required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1 lett. A) is in the
correct position.
To put the flame out, turn the knob to the symbol ".
• Always turn the flame down or put it out before
taking the pans off the burner.
Using the hob correctly
To ensure maximum burner efficiency, it is strongly
recommended that you use only pots and pans with a
bottom fitting the size of the burner used, so that flame
will not spread beyond the bottom of the vessel (see the
table beside).
It is also advisable, as soon as a liquid starts boiling, to
turn down the flame so that it will barely keep the liquid
simmering.
• Use only pans or pots with flat bottom.
Carefully supervise cookings with fats or oil, since
these types of foodstuff can result in a fire, if over-
heated.
36
Fig. 1
A - Burner cap
B - Thermocouple
C - Ignition candle
Burner minimum
Big (rapid)
Medium (semirapid)
Small (Auxiliary)
A
B
C
maximum
diameter diameter
180 mm. 260 mm.
120 mm. 220 mm.
80 mm. 160 mm.