Electrical Connection - Zanussi zgg 643 Bedienungsanleitung

Electrical Connection

The appliance is designed to be connected to 230 V
monophase electricity supply.
The connection must be carried out in compliance with
the laws and regulations in force.
Before the appliance is connected:
1) check that the main fuse and the domestic installation
can support the load (see the rating label);
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the socket or the double pole switch used for
the electrical connection can be easily reached with
the appliance built in the forniture unit.
The appliance is supplied with a connection cable. This
has to be provided with a proper plug, able to support the
load marked on the identification plate. To connect the
plug to the cable, follow the recommendation given in
Fig. 5. The plug has to be fitted in a proper socket.
If connecting the appliance directly to the electric
system, it is necessary that you install a double pole
switch between the appliance and the electricity supply,
with a minimum gap of 3 mm. between the switch
contacts and of a type suitable for the required load in
compliance with the current rules.
The connection cable has to be placed in order that, in
each part, it cannot reach a temperature higher than
90°C.
The brown coloured phase cable (fitted in the terminal
block contact marked with "L") must always be connected
to the network phase.
Replacement of the voltage
cable
Only cable type H05V
2
cable section must be suitable to the voltage and the
working temperature.
The yellow/green earth wire must be approximately 2
cm. longer than the phase wires (Fig. 5).
V -F T90 must be used. The
2
Earth (yellow/green)
FO 0073
Neutral
Fig. 5
39