Use Only As Authorized; Remaining Hazards - Scheppach Chisa 3.0 Original Anleitungen

the supply mains before recommissioning.
• Connection and repair work on the electrical
installation may be carried out by a qualified
electrician only.
• All protection and safety devices must be repla-
The machine corresponds to the valid EC
guideline.
• To transport the machine, grasp the table firmly
at the front and at the rear using both hands and
lift the machine.
• If an original base is not used, the machine must
be placed firmly upon a stable stand resembling
a table. The working height should be 850 mm.
• The machining range and surrounding areas of
the machine must be clear of interfering foreign
matter to prevent accidents occurring.
• Workpieces must be completely free of foreign
objects, i.e. nails or screws.
• The morticing machine is designed exclusively
for the machining of wood and materials similar
to wood. Only original scheppach tools and
accessories may be used. Please observe the
„Special Tool Accessories".
• The machine must only be used in technically
perfect condition in accordance with its desi-
D
gnated use and the instructions set out in the
operating manual, and only by safety-conscious
persons who are fully aware of the risks invol-
The machine has been built using modern
technology in accordance with recognized
safety rules. Some remaining hazards,
however, may still exist.
• The rotating work piece can cause injuries to
fingers and hands if it is incorrectly fed.
• Thrown work pieces can lead to injury if the work
piece is not properly secured or fed, such as
working without a limit stop.
• The use of incorrect or damaged mains cables
can lead to injuries caused by electricity.
• The operating instructions supplied with the spe-
Equipment Fig. 1
1 motor
2 switch
3 operating handle
4 chisels and drills
Use only as authorized 
Remaining hazards 
Montage
ced after completing repair and maintenance
procedures.
ved in operating the machine. Any functional
disorders, especially those affecting the safety
of the machine, should therefore be rectified
immediately.
• Relevant accident prevention regulations and
other, generally recognized safety-technical
rules must also be adhered to.
• The scheppach machine may only be used,
maintained, and operated by persons famili-
ar with it and instructed in its operation and
procedures. Arbitrary alterations to the machine
release the manufacturer from all responsibility
for any resulting damages.
• The scheppach machine may only be used with
original accessories and original tools made by
the manufacturer.
• Any other use exceeds authorization. The
manufacturer is not responsible for any dama-
ges resulting from unauthorized use; risk is the
sole responsibility of the operator.Remaining
hazards
cial accessories must be observed and carefully
read when scheppach special accessories are
used.
• Even when all safety measures are taken, some
remaining hazards which are not yet evident may
still be present.
• Remaining hazards can be minimized by fol-
lowing the instructions in „Safety Precautions",
„Proper Use" and in the entire operating manual.
5 support table
6 workpiece stop
7 workpiece guide rollers
8 workpiece blank holder
9 depth gauge
14