Installation In The Car - BabyGo TOJO Bedienungsanleitung

BabyGO
INSTALLATION OF THE SEAT IN A CAR
RECLINE POSITIN ADJUSTMENT

INSTALLATION IN THE CAR

14
BabyGO • www.babygo.eu
Note: The child restraint is only suitable for use with 3-point safety belts, appro-
ved to ECE R16 or equivalent standards.
Note: Before fixing a child in the child restraint, the seat must be set on the ma-
ximum recline position for rear-facing use, or in the sitting position for forward-
facing use. See following picture's solid pattern and dash pattern.
To achieve that, use the lever located in front of the child restraint between the
sitting part and the base to adjust the desire position. Pull up the lever and hold
it, at the same time pull back or forward the sitting part of the child restraint,
then release the lever while the sitting part is in the desired position and push
it until you hear a clear audible click sound.
Child safety seat must be used on the right seat of car.
Warning!
Extreme Danger: Do not use a rear-facing child restraint in passenger
seats equipped with airbag!
INSTRUCTION MANUAL
Tojo