SBS ekon ECREMOTE2 Bedienungsanleitung Seite 8

CLEARING ASSIGNED BUTTONS
CANCELLATION OF AN ALREADY ASSIGNED BUTTON
• Press and hold [MUTE] and [VOL +] for 3 seconds until the LED
turns on.
• Select the device you want to control using the button
corresponding to the device (e.g. TV). A correct selection is
indicated by the LED with a flash followed by a continuous light.
• Enter the code [9] [8] [1]; the LED will flash 2 times and then
stay on.
• Press and release the button on the universal remote from
which you want to delete the learned command. If the LED
flashes three times, the learned command has been cleared
successfully.
CANCELLATION OF ALL ASSIGNED BUTTONS
• Press and hold [MUTE] and [VOL +] for 3 seconds until the LED
turns on.
• Select the device you want to control using the button
corresponding to the device (e.g. TV). A correct selection is
indicated by the LED with a flash followed by a continuous light.
• Enter the code [9] [8] [2]; the LED will flash 2 times and then
stay on.
• Press and release the [SETUP] button on the universal remote
control. If the LED flashes 3 times, all commands have been
cleared correctly.
CODE SAVER
Codes will be saved permanently even when the batteries are
replaced.
8