Manual Code Search; Automatic Code Search - SBS ekon ECREMOTE2 Bedienungsanleitung

MANUAL CODE SEARCH

1 Turn on the device you want to control.
2 Press and hold the SETUP button on the remote control until
the red LED on the remote control turns on. Release the SETUP
button. The red LED will remain on.
3 Press and release the button corresponding to the device you
want to control (for example TV, decoder). The red LED will flash
once and stay on.
4 With the remote control aimed at the device, press and release
the POWER button or the P + / P- button on the remote control
to scroll through the preloaded codes, until the device you want
to control reacts.
5 Press the MUTE button to save the code and exit the code
search. The red LED will turn off.
Notes:
1 During code search, you can press the EXIT button to stop. The
red LED will turn off and the code will remain the same.
2 When all codes have been tried unsuccessfully, the remote
control will exit manual search and automatically return to
operating mode. The stored code is not changed.
3 In code search mode, only the OK, SETUP, POWER, and P + / P -
buttons function, not the others.

AUTOMATIC CODE SEARCH

1 Turn on the device you want to control.
NOTE: the automatic code search process cannot be used for
devices without on / off function. In that case, use the direct input
method.
2 Press and hold the SETUP button on the remote control until
the red LED turns on. Release the SETUP button. The red LED
will remain on.
3 Press and release the button corresponding to the device you
want to control (for example TV, decoder). The red LED will flash
once and stay on.
4 With the remote control aimed at the device, press and release
the POWER button or the P + / P- button on the remote control
to start automatic code search. The red LED will flash once
and then stay on. The remote control has a delay of 6 seconds
before the start of the first scan.
5 The red LED confirms each scan of a single code with a single
flash.
6 Press the MUTE button to save the code and exit the code
search. The red LED will turn off.
5