Learning Mode - SBS ekon ECREMOTE2 Bedienungsanleitung

Notes:
1 During code search, you can press the EXIT button to stop the
search and exit code search. The red LED will turn off and the
code will remain the same.
2 When all codes have been searched without success, the
remote control will exit automatic search and automatically
return to operating mode. The stored code is not changed.

LEARNING MODE

This remote control has a learning function. Therefore, it is
possible to transfer the functions of an original remote control to
the new remote control.
1. BEFORE STARTING LEARNING MODE
• The batteries of both remote controls must be in good condition.
Replace them if necessary.
• Position the remote controls with the infrared diodes pointing
at each other.
• If necessary, adjust the height of both remote controls so that
the infrared diodes are aligned correctly.
• The distance between the remote controls should be about 3
cm.
TV REMOTE CONTROL
notes:
• Do not move the remote controls during the learning process.
• Make sure that the room is not lit by fluorescent tubes or
energy-efficient lamps as such light sources may interfere with
copying.
• Both remote controls must be at least 1 metre away from any
light source.
• During learning mode, if no button is selected for more than 30
seconds, or if no other remote signal is received, the remote
control will automatically exit learning mode.
• Each function button will hold only one command. A new
command learned will automatically replace the previous one.
• It is not possible to learn new functions on the TV, TNT, and
SETUP buttons.
6
ca. 3 cm
ORIGINAL