IKA HELISTAND Bedienungsanleitung Seite 10

3.
Caution!
› Make make sure that the IKA HELISTAND is switched off!
Note: The switch indicator light is off�
› Push the pin downwards, the IKA HELISTAND will move down when the drive is switched on�
› Let the spindle run for one to two revolutions before turning on the IKA HELISTAND�
1...2 x
2.
18
1.
1.
2.
!
OFF !
1a.
1b.
/// Set limit stops
› Adjust the lower and upper limit stops� Make sure that the adjustment of the limit stops
corresponds to the required penetration depth of the spindle�
Note: The minimum allowed distance between spindle and vessel bottom is 6 mm�
› Switching on: Switch on the drive by flipping the switch�
Note: The switch indicator light will illuminate�
The speed of the up-and-down movement is 22�2 mm/min�
2.
1.
2.
!
3.
! Speed: 22.2 mm/min (50 Hz)
26.6 mm/min (60 Hz)
1.
ON
19