Troubleshooting; Sharpening Blades - VOSS.farming easyCUT go 85340 Bedienungsanleitung

During the charging process, the charging indicator lights up red. As soon as charging is
complete, the charging indicator lights up green.
Info
► Charging takes approx. 1.5-2 hours.
► If the batteries are hot (e.g. from devices that have just been used), the
charging indicator may not light up red. Let the battery cool down first,
preferably outside the charging station.
► If your charging indicator flashes red and green alternately, charging is not
possible. The connections on the battery or the charger may be dusty, worn
or damaged.
5. Remove the battery (4) from the charging station and disconnect the charging
station from the socket.
9.2

SHARPENING BLADES

CAUTION
Sharpening of the blades may only be carried out by specialist dealers using special
machines. Do not sharpen the blades yourself.
10

TROUBLESHOOTING

NOTICE
► Do not make any improper changes or modifications to the device.
► Never open the housing. Contact the service department for repairs.
If the device malfunctions or is found to be otherwise defective, even after following
the suggested solutions below, contact the service department. The contact details can
be found in chapter 14.
Problem Cause
1. Battery empty
Motor does
2. Battery, switch or
not work
1. Rotor runs out of round
Motor vibrates 2. Bearings are worn out
3. Fan wheel broken
1. Air filter is blocked
2. Blade tension is too
Motor gets hot 3. Blades or clipper head
4. Defective ball bearing
28
motor defective
high
run dry
INSTRUCTION MANUAL VOSS.FARMING EASYCUT GO
Motor
Solution
1. Change and charge the battery as
described in sections 7.4 and 9.1.
2. Contact the service department.
Contact the service department.
1. Clean or replace air filter.
2. Reduce the tension of the blades
with the tensioning nut. If this solves
the problem and the device does not
cut, the blades must be sharpened.
3. Oil the blades/head.
4. Contact the service department.
85340 | 02 | 2021 | V2