Troubleshooting - VOSS.farming EasyCUT 85285 Bedienungsanleitung

INSTRUCTION MANUAL VOSS.FARMING EASYCUT
10

TROUBLESHOOTING

NOTICE
► Do not make any improper changes or modifications to the unit.
► Never open the housing. Liability and warranty claims are excluded in the
event of repairs carried out by yourself, improper connection or incorrect
operation. Contact the manufacturer for repairs.
If faults occur with the unit, even after following the below solutions, or other defects
are found, contact the manufacturer. The contact details can be found in chapter 14.
Fault/Problem
Motor does not run
Motor gets hot
Motor vibrates
Motor is very loud
Fault /Problem
Upper blade is not
moving
Upper blade does
not move over
the entire running
surface
85285 | 11 | 2020 | V2
Motor
Cause
1. No current
2. Cable, Switch or
motor defective
1. Air filter clogged
2. Blade tension is too
high
3. Blade and/or head
are dry
4. Defective ball
bearing
1. Rotor runs out of
round
2. Bearings are worn
out
3. Fan wheel broken
Bearings seized up
Clippers head/Blades
Cause
Defective reduction
gearing
1. Eccentric knocked
out
2. Eccentric shaft
defective
Solution
1. Check the socket and fuse used
and have them checked/replaced
by qualified personnel if necessary.
2. Contact the manufacturer.
1. Clean or replace the air filter.
2. Reduce the tension of the blades
with the tensioning nut. If this
solves the problem
machine stops cutting, the blades
must be sharpened.
3. Lubricate the blades/ clipper head.
4. Contact the manufacturer.
Contact the manufacturer.
Contact the manufacturer.
Solution
Contact the manufacturer.
Contact the manufacturer.
DE
EN
EN
FR
IT
NL
SV
ES
PL
and the
27