Cleaning; Cleaning The Shaving Head - VOSS.farming easyCUT go 85340 Bedienungsanleitung

8

CLEANING

WARNING AGAINST ELECTRICAL VOLTAGES
Keep the device away from water or other liquids, electric shock or short circuit
may result.
CAUTION
Be careful to keep fingers away from the sharp edges of the blades to avoid injury.
NOTICE
Do not use aggressive solvents/cleaning agents, brushes, sharp objects etc. for
cleaning. These can damage the surface.
After each use, remove oil and hair from the clipper with a dry cloth and the cleaning
brush provided. Finally, oil the blades as described in section 7.3.
Clean the clipper head and the air filter at regular intervals.
8.1

CLEANING THE SHAVING HEAD

Clean the clipper head regularly. The cleaning cycle depends on how often the clipper
is used. Clean the clipper head at the latest as soon as the clipper blades are changed.
CAUTION
Be careful to keep your fingers away from the sharp edges of the blades to avoid
injury.
1. Switch off the clipper and remove the battery from the device (see section 7.4).
WARNING
Only carry out the following steps after ensuring that the device has been
switched off and the battery removed.
2. Remove the blades as described in section 7.5.
The inside of the shaving head is exposed.
3. Clean the inside of the shaving head and the blades thoroughly with the cleaning
brush provided.
4. After cleaning, mount and oil the blades again as described in section 7.5.
26
INSTRUCTION MANUAL VOSS.FARMING EASYCUT GO
85340 | 02 | 2021 | V2