OHAUS Navigator Bedienungsanleitung Seite 13

Navigator
6.3 Compliance
Compliance to the following standards is indicated by the corresponding mark on the product.
Mark Standard
This product conforms to the EMC directive 2004/108/EC, the Low Voltage Directive
2006/95/EC and the Non-automatic Weighing Instrument Directive 2009/23/EC. The
complete declaration of Conformity is available from Ohaus Corporation.
AS/NZS4251.1 Emission; AS/NZS4252.1 Immunity
EC Emissions Note:
This device complies with EN55011/CISPR 11 Class B Group 1.
Important notice for verified weighing instruments
The first stage of the initial verification has been carried out at the manufacturers work. It comprises
all tests according to the adopted European standard EN 45501:1992, paragraph 8.2.2.
If national regulations limit the validity period of the verification, the user of the weighing instrument
must strictly observe the re-verification period and inform the respective weights and measures
authorities.
In conformance with the European Directive 2002/96 EC on Waste Electrical and
Disposal
Electronic Equipment (WEEE) this device may not be disposed of in domestic waste.
This also applies to countries outside the EU, per their specific requirements.
The Batteries Directive 2006/66/EC introduces new requirements from September
2008 on removability of batteries from waste equipment in EU Member States. To
comply with this Directive, this device has been designed for safe removal of the
batteries at end-of-life by a waste treatment facility.
Please dispose of this product in accordance with local regulations at the collecting point specified
for electrical and electronic equipment. If you have any questions, please contact the responsible
authority or the distributor from which you purchased this device.
Should this device be passed on to other parties (for private or professional use), the content of this
regulation must also be related.
For disposal instructions in Europe, refer to www.ohaus.com/weee.
Thank you for your contribution to environmental protection.
Weighing Instruments verified at the place of manufacture bear one of
the preceding marks on the packing label and the green 'M' (metrology)
sticker on the descriptive data plate. They may be put into service
immediately.
Weighing Instruments to be verified in two stages have no green 'M'
(metrology) on the descriptive data plate and bear one of the preceding
identification marks on the packing label. The second stage of the initial
verification must be carried out by an authorized and certified service
organization established within the European Community or by the
National Notified Body.
EN-11