sylvac Hi_Gage ONE Smart Bedienungsanleitung Seite 21

13. List of the main commands
Selection and configuration
CHA+ / CHA- Change measurement direction
FCT0 ...9...A...F Assign "favorite" function
MM / IN Change measurement unit
KEY0 / KEY1 Lock / unlock keypad
PRE [+/-]xxx.xxx Modify preset value
REF1 / REF2 Change active reference
STO1 / STO0 Activate / deactivate HOLD
ECO1 / ECO 0 Activate / de-activate economic mode
LCAL dd.mm.yy Modify last calibration date
NCAL dd.mm.yy Modify next calibration date
NUM x...x (up to 20chars) Modify the instrument number
UNI1 / UNI0 Activate / deactivate unit change
OUT1 /OUT0 Active / deact. continuous data transm.
PRE ON / PRE OFF Active / deact. Preset function
PRE Recall Preset
SET Set to zero
SBY xx xx number of minutes before stand-by
BT0/BT1 Activate / de-activate Bluetooth
BTRST Clear pairing information
Interrogation
CHA?
FCT?
UNI?
KEY?
PRE?
REF?
STO?
ECO?
LCAL?
NCAL?
NUM?
?
SET?
ID?
SBY
module
®
Maintenance functions
BAT?
OFF
RST
VER?
MAC?
21
Measurement direction?
"Favorite" function active?
Active measurement unit?
Keypad locked?
Preset value?
Reference active?
HOLD function status?
Current economic mode
Date of last calibration?
Date of next calibration?
Instrument number?
Current value?
Main instrument parameters?
Instrument identification code?
Put instrument in stand-by (SIS)
Battery status (BAT1=OK, BAT0=low battery)
Complete sw. off (wake by button or RS)
Instrument reinitialization
Firmware revision and date
Bluetooth MAC address ?
®
E