Hercules HT 102 Bedienungsanleitung Seite 61

6.3.17 OVERVIEW OF THE TIGHTENING TORQUE OF BOLT CONNECTIONS
Mowing deck:
Central blade bolt
Nuts M12 on the mowing drive pulleys
Bolt 10x25 KL 100 RIPP on the arm of the mowing drive belt tensioning pulley
Steering:
Bolt M8x30 of the steering segment
M12 nut of steering segment
Engine:
Bolt of the electromagnetic clutch
Bolt of the travel belt pulley holder
When lock nuts are removed and then returned they need to be replaced with new ones.
6.4 LUBRICATION
Lubricate the machine according to figure 6.4 and the table below. In the event that the machine is operated in very dusty or sandy
operating conditions, lubricate more frequently.
Ball bearings of the tension pulleys, guide pulleys and bearings on the mowing deck are self-lubricating.
Prior to starting lubrication, the engine must be turned off and all moving parts of the machine must be still.
Symbol
50
(1)
(2)
(3)
(4)
6.4
(5)
(6)
(7)
(8)
(9)
(10)
(11)
Do not allow oil and lubricants to come into contact with the drive belts and their pulleys. Thoroughly wipe the area around the
lubricated parts before and after lubricating.
Prior to putting the machine out of operation for an extended period of time, thoroughly lubricate all locations shown on the picture,
particularly however the half shafts of the front and rear axles.
Plastic lubricant A00
Rotating central pin of the axle housing
Bearings of both front wheels and pins of the axle housing
Angle joint connecting steering draw rods
Rotating points of pedals on both sides of the machine
Bolt of the mowing deck elevation draw rod
Half axles of the rear wheels (transmissions)
Steering draw rod ball pan
Rotating points of the mowing deck elevation mechanism
Cogged steering segment, eccentric and angle joint of the steering draw
Angle joint connecting steering draw rods
Explanation
Interval in hours
rod
Front wheel pin
61
Torque
30 3 Nm
45 – 55 Nm
55 - 65 Nm
15 - 25 Nm
35 - 45 Nm
60 - 70 Nm
25 - 35 Nm
Activity
---
---
---
Lubricate through oiler
Lubricate through oiler
Remove and lubricate
Lubricate without removing
Lubricate without removing
Remove the wheel and
lubricate
Lubricate without removing
Lubricate without removing
Lubricate without removing
Lubricate through oiler
Remove and lubricate