Hercules HT 102 Bedienungsanleitung Seite 46

(21) AND (22) BY-PASS LEVER – FREE MOVEMENT OF THE REAR WHEELS
The by-pass lever serves to disengage the transmission for the rear wheel drive and is used to push or pull the machine without
using the engine. Depending on the type of transmission used, it is located either behind the rear left wheel or in front of the rear
left wheel. It has the following two positions:
ATTENTION!
engine is not running. During such movement the front axle is significantly overloaded and may be damaged. In the event that it is
necessary to move the machine with the engine turned off, always push the machine with the front axle lightened.
this procedure performed by a specialised service centre.
damage to the transmissions!
(23) FULL GRASS CATCHER FLAP
(24) SPRING FOR RETAINING THE GRASS CATCHER IN POSITION WHEN TRAVELLING IN TERRAIN
(25) FULL GRASS CATCHER SPRING SENSOR
Position Rear wheel drive
[0]
[1]
does not enable, for construction reasons, the disconnection of the front axle drive
Indicates that the grass catcher is full.
Retains the grass catcher in position when travelling across uneven terrain.
Engages the full grass catcher spring.
DISENGAGED When pushing the machine, the engine is still
ENGAGED When driving, the engine is running
46
Use
there is a danger of