Hercules HT 102 Bedienungsanleitung Seite 45

(17) MULCHING FLAP LEVER
The lever has two functions:
1) Grass collection –
2) Mulching –
Prior to shifting the lever from the grass collection position to the mulching position (down), first stop the machine and allow the
mowing deck to run approximately 20 seconds without the mowing function so that remaining glass clippings are blown out the
cause the incorrect function of the flap and the clogging of the ejection chute.
Setting the lever to position 1 (closer to the front wheels) opens up the mulching flap and grass is collected in the
grass catcher.
Setting the lever to position 2 (closer to the rear wheels) closes the mulching flap and grass is spread out under the
4.1b
lawnmower.
To ensure the correct function of the mulching flap, it is necessary to thoroughly clean out grass clippings and dirt from
the mowing deck and the ejection chute at the end of the mowing session.
(18) MOWING DECK ELEVATION ADJUSTMENT LEVER
The lever serves to set the elevation height of the mowing deck from the ground.
(19) MOWING DECK POSITION LOCK LEVER
The lever serves to lock the position of the mowing deck.
(20) GRASS CATCHER DUMP LEVER HANDLE
The lever serves to empty the grass catcher.
grass clippings are collected in the grass catcher
grass clippings are spread out under the lawnmower
The lever has 7 work positions, which correspond to a mowing height of 3 to 9.5 cm.
The higher the number of the lever position, the higher vegetation height remains after
mowing.
The lever can be used for the first four mowing deck positions. First tilt out the lock lever
upwards, then set the mowing deck lever to the appropriate position and lock this position by
tilting the lock lever downwards.
More information
7.
5.6.
45