Philips OneBlade Pro QP6520 Bedienungsanleitung Seite 5

- Always check the appliance before you use it.
Do not use the appliance if it is damaged, as this
may cause injury. Always replace a damaged part
with one of the original type.
Caution
- Never immerse the charging stand in water and do
not rinse it under the tap.
- Never use water hotter than 80°C to rinse the
appliance.
- Only use this appliance for its intended purpose as
shown in the user manual.
- For hygienic reasons, the appliance should only be
used by one person.
- Do not use the adapter in or near wall sockets that
contain or have contained an electric air freshener
to prevent irreparable damage to the adapter.
- Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as petrol
or acetone to clean the appliance.
Electromagnetic fields (EMF)
- This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
General
- This appliance is waterproof. It is suitable for use in the bath or shower
and for cleaning under the tap. For safety reasons, the appliance can
therefore only be used without cord.
- The appliance is suitable for mains voltages ranging from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe low voltage of less than
24 volts.
- Maximum noise level: Lc = 75dB(A)
Charging
QP6520/QP6510: Charging normally takes approx. 1 hour.
A fully charged appliance has an operating time of up to 90 minutes
(QP6520) or 60 minutes (QP6510).
Note: This appliance can only be used without cord.
Charge the appliance before you use it for the first time and when the
charge symbol indicates that the battery is almost empty.
Battery status indicator QP6520:
- When the charge symbol flashes orange, the battery is almost empty.
The remaining battery capacity is indicated by the battery status
percentage shown on the display.
ENGLISH
5