MaxPro PROFESSIONAL MPBBG150 Bedienungsanleitung Seite 8

• Guide the workpiece only against the switched-on machine and do not switch the machine off until after
having removed the workpiece. The workpiece can move suddenly.
• Never apply the workpiece laterally against the rotating grinding wheel, and always grind from the front.
The workpiece can be drawn out of your hand through the rotational motion of the grinding wheel and
lead to injuries.
• Never reach into the running grinding wheel of the machine.This can lead to serious injuries.
• Do not stop coasting grinding wheels by applying lateral pressure to them. The workpiece can be drawn
out of your hand through the rotational motion of the grinding wheel and lead to injuries.
• Wear a work apron. Pay attention that other persons are not put at risk from sparking. Remove flammable
materials in close vicinity. Sparking occurs when cutting metal.
• Keep your workplace clean. Blends of materials are particularly dangerous. Dust from light alloys can burn
or explode.
Products sold in GB only: Your product is fitted with an BS 1363/A approved electric plug with internal fuse
(ASTA approved to BS 1362). If the plug is not suitable for your socket outlets, it should be cut off and an
appropriate plug fitted in its place by an authorized customer service agent. The replacement plug should
have the same fuse rating as the original plug. The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a residual current device (RCD) with a rated residual current of 30
mA or less.
OPERATING INSTRUCTION
1.Mounting the machine (fig. A)
The machine must be screwed to a workbench. Mark the position of the mounting holes (8) on the
workbench. Drill holes at each of the marked position, adjusting the diameter and depth of the holes to the
screws used. Place the machine on the workbench and insert the screws into the mounting holes. Firmly
tighten the screws. Replacing a grinding wheel (fig. A & B) Remover the wheel guard (3). Loosen the nut (11).
The nut on the right spindle has a right thread, the nut on the left spindle a left thread. Remove the outer
flange (12) and the old grinding wheel (2). Clean the flanges (12 & 13). Place a new grinding wheel with
specified size. Fit supplied adaptor first if the wheel bore size is 32mm. Place the outer flange against the
grinding wheel and place the nut onto the spindle. Securely tighten the nut. Replace the wheel guard.
Always unplug the tool before replacing a grinding wheel.
Never use a cracked grinding wheel. Immediately replace a cracked grinding wheel.
A cracked grinding wheel may break into pieces when used and cause accidents.
2.Mounting and adjusting the spark guards (fig. A)
You must regularly adjust the spark guard in order to compensate the wear of the grinding wheel. Mount
the spark guard (4) to the wheel guard (3) using the screw (9) (refer to the figure). Adjust the distance
between the spark guard and the grinding wheel (2) to the smallest possible value, with a maximum of 2
mm. Tighten the spark guard screw. Slide the screen (5) to the front. Tighten the nut (10).
The spark guard protects your eyes and hands from sparks flying from the work piece.
Therefore, always use the spark guard.
3.Adjusting the work piece supports (fig. A)
You must regularly adjust the work piece supports in order to compensate the wear of the grinding wheels.
Loosen the adjusting screw (7). Adjust the distance between the work piece support (6) and the grinding
wheel (2) to the smallest possible value, with a maximum of 2 mm.
Tighten the adjusting screw.
EN 5