Before Use - Supra IRIS Bedienungsanleitung

English
FAN
Iris
DESCRIPTION
A Front Grill
B Propeller fastening nut
C Propeller
D Grill fastening nut
E Rear Grill
F Motor shaft
G Motor housing
H Oscillation knob
I Front motor housing
J Speed buttons
K Security screw
M Adjustable Height knob
N Adjustable Height Column
O Fan base cover
P Cross base
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if the on/off switch
does not work.
- Use the appliance handle/s, to catch it or
move it.
- Do not use the appliance if it is tipped up and
do not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains
when not in use and before undertaking any
cleaning task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Make sure that dust, dirt or other foreign
objects do not block the fan grill on the appli-
ance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
- Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- The appliance should be used with its base
fitted.
ASSEMBLING THE BASE FEET:
- The appliance has an anti-slip base feet that
support the product.
- Position the base feet on the body of the
appliance using the screws. (Provided with the
appliance). (Fig.1)
- Stand the appliance up again so as to check
that the base feet work properly.
ASSEMBLING THE GRILL AND THE PRO-
PELLER:
- Fit the rear grill (E) on the motor housing (G),
matching their fitting points.
- Tight the grill nut (D) that attaches the grill,
Make sure of a correct setting.
- Fit the propeller (C) on the motor shaft (F).
- Tight the nut (B) that attaches the propeller,
Make sure of a correct setting.
- Fit the front grill (A) front the rear grill (E),
matching the security screw position. Fix the
front grill by using the hooks and tight the
security screw (K) by using a screwdriver.
- Check the correct rotation of the propeller.
INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that all products' packaging has
been removed.