Before Use - Supra HEOS Bedienungsanleitung

English
Fan
Heos
DESCRIPTION
A Grille ring
B Nut and screw
C Front grill
D Propeller fastening nut
E Propeller
F Grill fastening nut
G Rear grill
H Motor shaft
I Motor housing
J Oscillation knob
K Speed buttons
L Desk fan base
M Screws for the base
N Non-slip feet
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if the on/off switch
does not work.
- Use the appliance handle/s, to catch it or move
it.
- Do not use the appliance if it is tipped up and
do not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the
appliance from operating correctly.
- Never leave the appliance connected and unat-
tended if is not in use. This saves energy and
prolongs the life of the appliance.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
ASSEMBLING THE BASE:
- To fix the base into the appliance, place the
appliance face down.
- Fit the base on the main body of the appliance.
- Fix the base using the screws provided (M).
- Stand the appliance up again so as to check
that the base works properly.
ASSEMBLING THE GRILL AND THE
PROPELLER:
- Fit the rear grill (G) on the motor housing (I),
matching their fitting points.
- Tight the grill nut (F) that attaches the grill,
Make sure of a correct setting.
- Fit the propeller (E) On the motor shaft (H).
- Tight the nut (D) that attaches the propeller,
Make sure of a correct setting.
- Fit the front grill (C) front the rear grill (G), mat-
ching the security screw position. Fix the front
grill turning around its fixing belt (A) and tight
the security screw (B) by using a screwdriver.
- Check the correct rotation of the propeller.
INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that all products' packaging has
been removed.
USE:
- Unroll the cable completely before plugging it
in.