Avdel ESN50LAV Bedienungsanleitung Seite 21

Instruction Manual
Riveting tool ESN50LAV
The compact ergonomically formed design consists
2K
of 2 components. The grip area is rubber coated
and therefore slip resistent. The housing design is
optimized in respect of the center of gravity which
improves the handling and supports fatique-proof
working.
Li-Ion batteries do neither have a memory effect nor
self discharge. Even after long periods of non ope-
ration the tool is always ready to operate. In addition
we see a lower power weight ratio with 50% more
capacity and shorter charging cycles compared to
NiMH batteries.
3.3 Description of the tool indication
See Tab. 2.
Prior to operating the unit the charging level of the batte-
ry should have been tested. A low charging level can be
detected by the fl ashing of the LED for 20 s at the end of
a riveting cycle.
3.4 Assembly of the C-frame
see pic. in front
1. Retract the piston completely (possibly press the re-
tract button.
2. Loosen the hexagon socket head cap screw at the
C-frame and loosen the head plate.
3. Unscrew the C-frame.
4. Remove the aluminium cover from the riveting head
and screw it on the other riveting head which is not
needed. The hexagon socket head cap screw must be
completely screwed in to avoid damages during sto-
rage.
Attention
Avoid debris such as dust and dirt to penetrate
the cylinder while changing the C-frames.
5. Loosen hexagon socket head cap screw and screw the
C-frame onto the base tool
6. Fix the C-frame with hexagon socket head cap screw
and iron plate.
4. Remarks in respect of the
determined use
4.1 Operation of the unit
Cycle: see pictures in front
First the proper tool kit are selected for the required ap-
plication.
Attention
Do not operate the tool without workpiece/pla-
tes
Now the working cycle will be proceeded.
Attention
The riveting process can be interrupted at any
moment by releasing the Trigger.
Attention
Do always adjust the joining force according to
your current application. Ignoring that warning
might destroy the tool kit.
HE.17489_A © 06/2016
Attention
If you feel resistance while turning the adjust-
ment screw stop immediately. Ignoring that war-
ning might break the cap screw.
Attention
Use eye protection when operating the
tool.
Attention
After having terminated the working cycle and
prior to changing the tool kit remove battery to
avoid unintended use. Avoid unintended starts.
Make sure the switch is in the off position before
plugging in.
Attention
Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves
away from moving parts.
Attention
Keep work area clean and organised. Cluttered
and dark areas might trigger accidents.
Attention
Keep proper footing and balance at all times.
Attention
Use safety gear and always wear eye protection.
4.2 Explanation of the application range
The tool is hand helded and it is not supposed to be re-
strained in a vise. It is not allowed to use the tool in a
stationary application.
The tool is not designed for continued operations. After
a sequence of approximately 150-200 completed cycles
you have to make a break of 15 min. to give the tool time
to cool down.
Attention
Too intensive use can cause heat damages for
the tool
Attention
During the operation of electric engines sparks
can occur which might ignite highly infl ammab-
le or explosive liquids and materials.
Attention
Electric-hydraulic tools should not be operated
in pouring rain or under water.
2
GB