Remarks In Respect Of The Determined Use; Operation Of The Unit - Avdel ESN50LAV Bedienungsanleitung

Instruction Manual
Riveting tool ESN50LAV
4. Remarks in respect of the
determined use

4.1 Operation of the unit

Cycle: see pictures in front
First the proper tool kit must be selected for the required
application.
WARNING
Do not operate the tool without workpiece/sheet
metal. This might destroy die and/or punch.
WARNING
The riveting process can be interrupted at any
moment by releasing the Trigger in case of emer-
gency.
WARNING
Do always adjust the joining force according to
your current application.
Ignoring that warning might destroy the tool kit and
might fracture and hurt nearby personell.
WARNING
If you feel resistance while turning the adjustment
screw stop immediately.
Ignoring that warning might break the cap screw.
Use eye protection when operating
the tool.
After having terminated the wor-
king cycle and prior to changing
the head/tool kit remove battery
to avoid unintended use. Avoid
unintended starts. Make sure the
trigger is in the off position before
inserting the battery.
CAUTION
Dress properly. Do not wear loose clothing or jewel-
lery. Keep your hair, clothing and gloves away from
moving parts.
HE.17489_A © 06/2016
WARNING
WARNING
CAUTION
Keep work area clean and organised. Cluttered and
dark areas might trigger accidents.
WARNING
Keep proper footing and balance at all times.
WARNING
Use safety gear where appropiate.
4.2 Explanation of the application range
The tool is hand helded and it is not supposed to be restrai-
ned in a vise. It is not allowed to use the tool in a stationary
application.
The tool is not designed for continued operations. After a
sequence of approximately 150-200 completed cycles you
have to make a break of 15 min. to give the tool time to
cool down.
CAUTION
Too intensive use can cause heat damages for the
tool
WARNING
During the operation of electric engines sparks can
occur which might ignite highly infl ammable or ex-
plosive liquids and materials
WARNING
During the operation of electric engines sparks can
occur which might ignite highly infl ammable or ex-
plosive liquids and materials
WARNING
Electric-hydraulic tools should not be operated in
pouring rain or under water.
CAUTION
Only those punches and dies should be used which
are suitable for the material and sheet thickness.
CAUTION
Do not use the last rivet on the belt. Disregarding
this warning can result in damaging the belt feed
mechanism because a minimum of 2 rivets are ne-
cessary to transport/position the rivet properly
4
US