Technical Data - Avdel ESN50LAV Bedienungsanleitung

Instruction Manual
Riveting tool ESN50LAV
4.3 Service and maintenance instruction
For every day service the tool has to be cleaned and dried
after each use. The battery cartridge and the charging unit
have to be protected against humidity and dust.
WARNING
Maintain power tools thoroughly. Check for func-
tionality or jamming of moving parts, breakage of
parts and any other condition that may affect the
power tools operation.
4.3.1 Service
The tool is equipped with a controller enabling the user to
see when the next service is due by fl ashing for 20 sec. at
the end of a working cycle. When the next service is due
after 10.000 cycles the unit must be returned to an autho-
rised service center. Failure to observe this request results
in loosing the Warranty. Preventive maintenance serves
your safety.
CAUTION
Do not damage the seals of the tool
CAUTION
Have the power tool repaired by a qualifi ed expert
before use.
4.3.2 Cleaning
Where the tool is used in a environment containing adhesi-
ves etc. a method of completey removing such substances
should be employed when cleaning parts. We defer res-
ponsibilty to the customer for the choice and safe use of the
solvents or other substances.
CAUTION
Ensure that there is no debris in the cylinder area.
Metal chips can damage the cylinder walls and re-
sult in leakages.
WARNING
Do not cycle tool without rivets and material!
CAUTION
Clean the threads of the riveting head and cylinder
area before the assembly/change of the head.
HE.17489_A © 06/2016
4.4 Daily Maintenance
Check die for wear, especially on the centre 'pip' on an
•
upsetting die, use a new die for comparison. Clean out
metal deposits.
4.5 Reference as to which spare parts
can be exchanged by the customer
Within the determined use of the tool only the dies and pun-
ches are permitted to be changed by the customer.
5. Troubleshooting
a.) Constant fl ashing/indicating of the red LED.
 see table 2. If the failure can not be solved return the
tool to the nearest service center (ASC).
b.) The tool loses oil.
 R eturn the unit to the manufacturer. Do not open it
and damage the seal of the tool.
c.) The red LED fl ashes 3x and simultaneously 3 acou-
stic warning signals occure (see table 2).
 Serious fault! If this fault occures repeatedly return
the unit to an Autorized Service Center (ASC). Do
not open it and damage the seal of the tool.

6. Technical Data

Weight ESN50LAV: 3,4 kg
(incl. battery): ESN50LAV: 7.5 lb
Stroke: see tab.1
approx. 20 - 50 kN
Joining force
(adjustable)
: approx. 2.25 - 5.62 tons
Downholder force: approx. 20% of the joining force
Battery voltage: 18 V
Battery capacity 3 Ah (RAL2/BL1830)
Charging time: 22 min. (RAL2/BL1830)
Riveting time: 3 - 5 s
Capacity: approx. 4
(depending on the force
adjustment and riveting size)
Hydraulic oil: Rivolta S.B.H. 11
Environmental -12°C to +40°C
temperature: 10.4°F to 104°F
Sound level: < 70 dB (A) in 1m distance
Vibrations: < 2,5 m/s²
< 8.2 ft/s²
00 rivets
5
US