Maintenance - Comelit UT1010 Programmieranleitung

output for the module). NOTE: Module SE Output and/or module Relay Output must be set in the menu
"Outputs" > SE Output and/or Relay Output with "Function" > Lock-release and/or actuator
◊ Control on Ultra bus (UDB): activates the relay on the number keypad specified in the "Type" field
(Relay 1 or Relay 2)
◊ Actuator control: activates the actuator with the address specified in the "Actuator address" field
(from 1 to 255)

MAINTENANCE

Restarting the device
To restart the module:
1. select it
2. right-click on the description (a pop-up with 5 sub-menus will appear)
3. select "Restart device" or
4. click which appears on the menu bar
Resetting the device
To restore the factory settings of the module:
1. select it
2. right-click on the description (a pop-up with 5 sub-menus will appear)
3. select "Reset device" (an alert/confirm procedure request window appears)
Resetting call button programming
To delete the call address programming for the buttons:
1. select the module
2. right-click on the description (a pop-up with 5 sub-menus will appear)
3. select "Reset Call Directory" (an alert/confirm procedure request window appears)
Updating device firmware
To update the module firmware:
1. select it
2. right-click on the description (a pop-up with 5 sub-menus will appear)
3. select "Download firmware" or
4. click which appears on the menu bar
Notes
1. If you need to update the module from a version preceding 1.1.1 to a version higher than 1.1.1, you must
12
Audio