Declaration Of Conformity - Yard Force SA650ECO Originalbetriebsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

TROUBLESHOOTING

Nr. Message

Symptom

The Robotic Mower

does not receive the

boundary wire signal.

LED flash

(Robotic Mower placed

inside boundary area.)

Battery voltage is

too low to perform

LED flash

normal mowing.

Charging

LED flash

Reset factory defaults

Action

1. Verify that the docking station indicator light

is blue. If not, refer to installation instructions

and docking station troubleshooting.

2. Verify that both docking station and Robotic

Mower are set to the same signal, S1 or S2.

3. Check if the boundary wire is connected in

the correct direction.

4. Disconnect the boundary wire from the

docking station, and reconnect it the

opposite way.

1. Normally if voltage is low, the mower should

automatically return to the docking station.

2. If not, please carry your mower manually to

docking station when it has stopped on the

lawn.

Wait for battery to recharge.

1. Switch OFF the device.

2. Place Robotic Mower on flat, even surface.

3. While pressing and holding the START

button, switch ON the device.

4. The Robotic Mower will boot up. All LEDs

flash.

5. Release START button. Factory reset is

complete.

Note: The Robotic Mower must stand on a flat

surface, because the inclination sensors are

also zeroed.