Supra ARTEMIS Handbuch Seite 8

English
FAN
Artemis
DESCRIPTION
A Front grill
B Guard securing
C Front cover
D Spinner lock nut
E Propeller
F Guard lock nut
G Rear grill
H Motor shaft
I Shaft pin
J Oscillation control knob
K Handle
L Motor cover
M Bulge
N Upper stand tube
O Lower stand tube
P Speed button
Q Screw
R Base plate
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if the on/off switch
does not work.
- Use the appliance handle, to catch it or move it.
- Do not use the appliance if it is tipped up and do
not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children and/
or persons with physical, sensory or reduced
mental or lack of experience and knowledge.
- Make sure that dust, dirt or other foreign objects
do not block the fan grill on the appliance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
- Never leave the appliance connected and unat-
tended if is not in use. This saves energy and
prolongs the life of the appliance.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- The appliance should be used with its base
fitted.
ASSEMBLING THE BASE:
- Insert the lower stand tube (O) into the base
hole (R) and keep the bulge (M) of the stand
tube alignment with space of the base hole.
- Then use four screws (Q) tighten (Fig.1).
- Insert the upper stand tube (N) into the lower
stand tube (O) by hand near the thread zone
and turning it in a clockwise direction (Fig. 2).
ASSEMBLING THE GRILL AND THE PROPEL-
LER:
- Remove the spinner lock nut and guard lock nut
from the motor shaft spindle.
- Fit the rear guard, by positioning on the location
pins.
- Secure the guard to the motor body with the
guard lock nut (Fig. 3).
- Push the fan blade onto the motor shaft by
matching the slots on the base of the blade with
the shaft pin.
- Secure the blade with the spinner lock nut. The
spinner lock nut must be tightened by turning it in
a counter-clockwise direction. Check that the fan
blades rotates freely by turning with your hand.
- Place the front grill in front of the rear grill. Fix
the grills with the fixing belt and tighten the
security screw using a screwdriver.
INSTRUCTIONS FOR USE
BEFORE USE:
- Remove the appliance's protective film.
- Make sure that all products' packaging has been
removed.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using one of the