IARP DELIGHT 16 Betriebsanleitung Für Betreiber Seite 30

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
25. DISPENSER WASH ASSEMBLY (Optional)
To assemble the dispenser wash, proceed as follows:
Screw in the dispenser wash support (A) with the dispenser wash (B)
using the screw (C) on the back of the equipment.
With water recirculation:
• Fasten the water filling joint (3) with the incorporated valve,
positioned as in the illustration, to the tank (2) using the fastening
nut (4);
• Connect the stainless steel "overflow" tube (7) to the bushing (6)
and fasten it to the tank with the nut (5);
• Connect the water filling joint (3) to the rubber tube to a tap and
fill the tank (2) of clean water;
• Connect the rubber tube to the bushing (6) and drain the excess
water or dirt (filtered from the cover/partition (8)) into a sink.
Without water recirculation:
• Fasten the water filling joint (3) with the valve, positioned as in
the illustration, to the tank (2) using the fastening nut (4);
• Connect the stainless steel "overflow" tube (7) to the bushing (6)
and fasten it to the tank with the nut (5);
• Connect the rubber tube to the bushing (6) and drain the excess
water or dirt (filtered from the cover/partition (8)) into a sink.
• Manually fill the tank with clean water.
DELIGHT 16
DELIGHT 18
DELIGHT 20
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
3 0 / 8 4
PAGE
UM000494
N° DOC
A
C
1
2
3
4
1
2
4
3
B
8
7
6
5
8
7
6
5