Columbus ST 7 Handbuch Seite 4

1 Safety
Observation of the safety instructions permits optimal protection of the personnel and third parties from hazards and ensures safe and
reliable operation of the equipment.
This chapter contains an overview of all important safety aspects.
The pictograms, signs and instructions on the appliance must be observed and kept in readable condition.
1.1 Introduction
The appliance conforms to the current standard of technology and operational safety.
However, dangers can arise from this appliance if it is used by not properly trained personnel, used improperly or used for a purpose other
than that intended.
Every person, who is asked to work with or carry out work on the appliance, is required to read the operating manual and have understood
it before working with the equipment.
Knowledge of the content of the operating manual is a prerequisite for protecting personnel for danger and avoiding mistakes and thus
ensure safe and reliable operation of the appliance.
To avoid danger and ensure optimal performance, no modifications or changes may be made to the equipment, unless they have been
expressly approved by the manufacturer.
All safety signs and operating instructions on the appliance must always be kept in a clearly readable condition. Damaged or unreadable
signs must be replaced immediately.
It is the duty of the operator to report any changes in the way the appliance works, which could affect safety, immediately to the person
responsible.
1.2 Responsibility of the owner / operator
The appliance may only be used when it is in a safe condition and in perfect working order. The owner/operator is responsible for ensuring
reliable operation of the equipment. The instructions given in the operating manual are to be respected in full and without reservations!
The statements about the work safety refer to the directives of the European Union, valid at the time of manufacture of the
appliance. During the entire working life of the equipment, the owner/operator is obliged to compare the above mentioned
safety protection measures with those currently in force and heed any new rules which may have been introduced
subsequently. Outside the European Union, the work safety laws and local regulations valid where the equipment is used
must be respected.
1.3 Proper use
The unit is only to be used for cleaning dry areas and is not suitable for removing dust which is hazardous to your health.
WARNING! Risk of injury!
Never Vacuum up the following materials:
explosive or combustible gases, liquids and dust particles (reactive dust particles).
−
reactive metal dust particles (such as aluminium, magnesium, zinc) in combination with highly alkaline or acidic detergents.
−
undiluted, strong acides and alkalies.
−
organic solvents (such as petrol, paint thinners, acetone, heating oil).
−
In addition, these substances may cause the appliance materials to corrode.
Do not draw in burning or glowing objects.
Do not vacuum up people or animals.
In case of low temperatures, the unit may not be used outdoors.
ATTENTION!
Only use accessories and spare parts which have been approved by the manufacturer. Original accessories and spare parts guarantee
that the unit can be operated safely and whithout any breakdowns.
1.4 Work safety
Danger to persons and/or the equipment can be avoided by following the work safety instructions.
Non-observance of these instructions can put people or objects at risk through mechanical or electrical factors or through the equipment
breaking down.
ATTENTION!
Non-observance of the safety regulations will result in the loss of any right to claim for damage.
The voltage indicated on the rating plate must correspond to the voltage of the power source.
3
Vacuum Cleaner ST 7
Safety