Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 37

6. CARE AND MAINTENANCE

Before cleaning your appliance (something that should be done regularly), disconnect it by removing
the plug or by pulling the fuse on the circuit.
Before using your appliance for the first time and regularly after that, we recommend that you clean
the inside and outside (front, side and top) with warm mixed with a gentle cleaning product. Rinse with
clean water and allow to dry before reconnecting. Do not use solvents or abrasives.
When the appliance is switched on for the first time, there may be a residual odour. In that case, runt
the appliance empty for a few hours at the coldest possible temperature. The cold will kill any odours.
In case of a power cut
Most power cuts are resolved within a short time. A power cut of 1 or 2 hours will not affect the
temperature in your device. During very long power cuts, take the necessary measures to protect your
wine.
• If the appliance is disconnected or if there is a power cut, you must wait three to five minutes
before re- starting. If you try to re-start before this time, the compressor will only re-start after 3 to 5
minutes (if the temperature requires).
• When switching on for the first time or following a prolonged shutdown, it is possible that when re-
starting, the temperatures selected and those displayed are not the same. This is normal. It will
take a few hours before they stabilize.
Moving your bottles cooler
• Unplug your device before any operation
• Remove all the bottles present in the tank and fix the moving parts
• When moving your appliance, make sure that it is always in a horizontal position and that it is not
inclined more than 45 ° C. It must also not be positioned upside down.
• Protect outside of appliance with a blanket, or similar item.
Energy saving tips
• The device should be located in the coolest area of the room (but at least at 16°C), away from heat
producing appliances, and out of the direct sunlight.
• Ensure that the unit is adequately ventilated. Never cover air vents.
32

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis